Volkswagen Polo: VW Polo Service and Repair Manual - Volkswagen Polo Repair ManualVolkswagen Polo: VW Polo Service and Repair Manual

The updated VW Polo range was introduced in November of 1990, with a choice of 1.05 litre (1043 cc) or 1.3 litre (1272 cc) petrol engines, with either single-point or multi-point fuel injection. During Spring 1991, the G40 model was launched, equipped with a supercharged version of the 1.3 litre engine. Three body shells are available - a three-door hatchback, a two-door saloon and a three- door Coupe.

All engines are derived from the well-proven units which have appeared in previous versions of the VW Polo. The engine is of fourcylinder overhead camshaft design, mounted transversely, with the transmission mounted on the left-hand side. All models have a four or five-speed manual transmission.

Introduction
The updated VW Polo range was introduced in November of 1990, with a choice of 1.05 litre (1043 cc) or 1.3 litre (1272 cc) petrol engines, with either single-point or multi-point fuel injection. D ...

See also:

Interior lights
During entry and exit of the vehicle, the front and centre courtesy lights automatically come on and then switch off after a delay. Front courtesy light Centre switch position: automatic interio ...

Sump - removal and refitting
Removal 1 Disconnect the battery negative cable, then carry out the following operations: a) Apply the handbrake, chock the rear wheels, then jack up the front of the car and support it on axl ...

Handbrake cable - removal and refitting
Front cable Removal 1 Chock the front wheels then jack up the rear of the car and support on axle stands (see “Jacking and vehicle support”). Release the handbrake. 2 If fitted, remove the pl ...