Opel Corsa: Seat belts
The belts are locked during heavy acceleration or deceleration of the vehicle for the safety of the occupants.
Fasten seat belt before each trip.
In the event of an accident, people not wearing seat belts endanger their fellow occupants and themselves.
Seat belt reminder .
Seat belts are only designed for use by one person at a time. They are not suitable for people younger than 12 years of age or smaller than 150 cm (5 ft).
Periodically check all parts of the belt system for damage and proper functionality.
Have damaged components replaced. After an accident, have the belts and triggered belt tensioners replaced by a workshop.
Make sure that the belts are not damaged by shoes or sharp-edged objects or are trapped. Prevent dirt from getting into the belt retractors.
Belt force limiters
Located in the front seats. Stress on the body is reduced by the gradual release of the belt during a collision.
In the event of a head-on or rear-end collision of a certain severity, the front seat belts are tightened.
Incorrect handling (e.g. removal or fitting of belts) can trigger the belt tensioners with risk of injury.
Deployment of the belt tensioners is indicated by continuous illumination of control indicator .
Triggered belt tensioners must be replaced by a workshop. Belt tensioners can only be triggered once.
Do not affix or install accessories or other objects that may interfere with the operation of the belt tensioners.
Do not make any modifications to belt tensioner components as this will invalidate the vehicle type approval.
Selecting reverse gear CAUTIONS. Do not engage reverse gear when the vehicle is moving. This can cause damage to the transmission. Fully depress the clutch pedal and wait for three seconds before ...
■ Always apply parking brake. Manual parking brake without pressing release button. Apply as firmly as possible on a downhill slope or uphill slope. Operate foot brake at the same time to red ...
HOW TO USE THIS MANUAL
1. BODY PANEL REPLACEMENT IN THIS MANUAL 2. SYMBOLS The following symbols are used in the welding diagrams in section BP of this manual to indicate cutting areas and the types of weld required ...