Hyundai Accent: Malfunction Indicator Light - Warning and Indicator Lights - Features of your Hyundai - Hyundai Accent Owners ManualHyundai Accent: Malfunction Indicator Light

This light illuminates when there is a malfunction of an exhaust gas related

This light illuminates when there is a malfunction of an exhaust gas related component and the system is not functioning properly. This light will also illuminate when the ignition key is turned to the "ON" position, and will go out in a few seconds after the engine is started. If it illuminates while driving, or does not illuminate when the ignition key is turned to the "ON" position, take your car to your nearest authorized Hyundai dealer and have the system checked.

CAUTION:

Prolonged driving with the Emission Control System Malfunction Indicator Light illuminated may cause damage to the emission control systems which could effect drivability or fuel economy. If the Emission Control System Malfunction Indicator Light begins to flash ON and OFF, potential catalytic converter damage is possible. This could result in loss of engine power. Have the Engine Control System inspected as soon as possible by an authorized Hyundai dealer.

    Check Fuel Filler Cap Warning Light
    This warning light indicates the fuel filler cap is not tight securely. Always make sure that the fuel filler cap is tight. ...

    Seat Belt Warning Light and Chime
    The driver's seat belt warning light and chime will activate to the following table when the ignition switch is in "ON" position. *1) Warning pattern repeats 11 times with an inte ...

    See also:

    Electrical circuit protection
    Fuses A vehicles electrical system is protected from electrical overload damage by fuses. This vehicle has two fuse panels, one located in the driver's side panel bolster, the other in the ...

    Front track control arm and balljoint - removal and refitting
    Removal 1 Jack up the front of the car and support on axle stands (see Jacking and vehicle support). Apply the handbrake and remove the roadwheel. 2 Unscrew the clamp bolt securing the con ...

    Loudspeakers - removal and refitting
    Removal 1 The loudspeakers are located at each end of the facia panel. Using a screwdriver carefully prise the grille from the top of the facia panel (see illustration). 17.1 Use a screwdriv ...